Build Your Own Board … Easy as 1, 2, 3

With the Micro Mezzanine System you can mix and match modular components to build unique board-level solutions. Custom solutions that you conceive and we help you create.

Your boards, Your way!

  1. Pick an ECM carrier with the FPGA density and features you need.

  2. Pick from an expanding assortment of ECMs the module(s) that offer
      the functions and characteristics appropriate for your intended application.

  3. Assemble the hardware, load the corresponding IP and module code, and go!

You choose the carrier. You choose which sites to populate with ECMs. And if you later need to modify the board, you change only modules. The physical interface remains constant.

No other modular board system comes close to the level of granularity and creative flexibility offered by the Micro Mezzanine System.

And it's only from Technobox.

Moving Forward: Defining Your Micro Mezzanine System Solution

If you are interested in moving ahead with MMS, you can submit an MMS RFQ.

There are two ways to proceed. You can  Configure an MMS Solution  or  choose from a variety of Pre-defined MMS Hardware Configurations.

Because these are system solutions, we will review your selections and contact you to discuss the intended application. We do this to verify suitability of the chosen MMS solution -- particularly the carrier and ECMs -- making sure that the chosen components will meet the intended application.

If you choose to configure a new MMS solution, we will assign a unique orderable top assembly part number (P/N) for continuity and convenience. The assigned P/N subsumes all the elements of the the complete MMS configuration  ---  the carrier, chosen ECM(s), ECM locations, and the IP  ---  for future reference.

Even if you select an exsiting P/N, any change in IP will require assignment of a new P/N to identify the newer configuration.

Please note that IP is a critical consideration, and, depending on the complexity of the IP effort, charges may apply.

By employing unique P/Ns, you are not only assured that hardware is properly assembled, you can be certain that IP will be installed to match the assembly and provide the desired I/O control functions.

And, finally, if you want to employ your own IP, we will assign a unique P/N for the hardware to prevent confusion with any similar MMS solution.

No confusion. No questions. You will always get the same MMS solution